To see the full image of the pin click on the individual picture.

 

Greetings to everyone. Just a little more personal information. Many folks know me as the Pin Lady. I developed a technique to create pins from stamped images on layered cardstock. When the pin is complete it looks like it is a ceramic pin. I plan on creating some terrific pins from the new catty, but until then I am showing some of my pins created from some of the retired sets.

  GENERAL PIN INSTRUCTION Design and Technique by Kelli Purkey

1. Layer 3 sheets of desired card stock.  Stay primarily with the Soft Subtles, Earth Elements, Ultrasmooth  White and

Natural cardstocks,as the color turns quite a bit darker when sprayed with the Krylon spray. Always test a sample so

you don’t build your project andfind out it sprays too dark.

 

2. Stamp Image on the top sheet with your desired cardstock. On some I use Basic Black stamp pad and on  some the

craft pads with clear embossing powder. It depends upon the desired finished look. Color your image if needed.

 

3. Cut a square around the stamped image cutting thru all 3 layers. The bottom layer set of the pin is always 3 pieces

of cardstock, each set layer after that is either 2 or 3 layers sheets of cardstock depending upon the design..

 

4. Turn over the top sheet with the image, Smear tacky glue onto the cardstock, then adhere to 2nd sheet of Cardstock,

Smear tacky glue to the back of the 2^nd piece of cardstock and adhere to the 3rd layer of cardstock.

 

5. Cut out the image while the tacky glue is still wet (all 3 layers are glued together as one for cutting).

 

6. While the tacky glue is still wet, form the pin and let it dry. Do the same with each additional layerset.

(Use only 2 sheets of c/s for the additional layers sets).

 

7. Use your marker (usually black) to color all edges unless you are embellishing with embossing powder. If you are

embellishing your pin edges with metallic embossing powder, squeeze out a dab of tacky glue on a piece of paper,

use your finger or a tooth-pick to apply a small amount of the glue to the edges of your pins. Dip it in your

embossing powder and heat with your heat gun. The glue will bubble up as the powder melts and create a nice edging.

 

8. Repeat steps 1 thru 7 for each additional pin layer, using 2/3 pieces of cardstock

 

9. Put together multiple pin layers with dots of tacky glue. Let Dry.

 

10. Spray your pin with 5 to 6 layers of Krylon Triple Thick Crystal Clear Glaze (Until you get the amount of shine

that you want.) Spray both the front and back of the pin.

11. Embellish as desired. Always add the Rhinestones after all spraying is completed.

12. Adhere magnet or pin back using tacky glue. If  you are making the magnet pin  (no more holes in your clothes)

use a 2nd magnet for your pin to adhere to on the inside of you blouse or dress.

 

Trackback URI | Comments RSS